Electrolux EWX13611 Service Manual page 25

LED lit up
- Door safety interlock
- Wash solenoid, if the water in
the tub is not enough to cover
the heating element
- Heating element
- Recirculation pump
- Door safety interlock
- Wash solenoid, if the water in
the tub is not enough to cover
the heating element
- Motor (55 rpm clockwise,
55 rpm anti-clockwise,
250 rpm pulse)
- Door safety interlock
- Drainage pump
- Motor up to 650 rpm then
at maximum spin speed (**)
Reading/Deleting the last alarm
- The LEDs light up in sequence,
the symbols on the LCD display
light up in in groups and the
backlighting comes on
- Touch a sensor to turn on the
group of icons in the LCD
screen or the corresponding
LED and the buzzer sounds
at the same time
(*) In most cases, this time is sufficient to check the heating. However, the time can be increased by repeating the phase without draining the
water: pass for a moment to a different phase of the diagnostic cycle and then back to the heating control phase (if the temperature is higher
than 80 °C, heating does not take place).
(**) The check at the maximum speed occurs without control of the A.G.S. and no garments must be inside the appliance.
Technical Support - MDM
Components activated
-----
Working conditions
Door closed
Water level above
the heating element
Maximum time 10 min.
up to 90 °C (*)
Door closed
Water level above
the heating element
Door closed
Water level lower
than anti-boiling level
for spinning
-----
-----
Always active
25/104
Function tested Display
Temperature in
Reheating °C measured
Circulation using the
NTC probe
Check for leaks Drum speed
from the tub. in rpm/10
Drain, calibration
of analogue Drum speed
pressure switch in rpm/10
and spin.
-----
-----
User interface
functions
599 77 39-16 Rev. 00
-----
-----