Electrolux EWX13611 Service Manual page 15

 Sensor no.5: START/PAUSE
This sensor has the START/PAUSE function, used to start up a washing programme,
after selecting the washing cycle and required options; it can also pause a cycle that
has already started: to allow you to change selected option or open the door (if the
L24
temperature conditions or water level allow for this).
The cycle re-starts if you touch the sensor again.
The (L24) LED combined with this sensor flashes slowly: in the selection phase, during
the pause and at the end of a cycle with water in the tub.
S5
It stays lit when a cycle is running and turns off when the cycle has ended and the door
is unlocked.
While other sensors when touched immediately change from selected to de-selected,
in the case of this sensor, more time is needed to avoid unwanted cycle start ups
or pauses.
In the event of an incorrect selection by the end user, such as: an option that is not
compatible with the selected programme or that has been made after the programme
has commenced, this is indicated by three quick red flashes. The same LED is used to
notify the user of any specific problems with the appliance. The buzzer does not play
any particular tune.
 Sensor no.6:- DELAYED START (configurable)
This sensor works as the DELAYED START and it is combined with the three
L25
LEDs (L25÷L27) that surround it.
L26
Touch it in sequence to choose from one of the three delayed start options: 3 h-
6 h-9 h with the related LED coming on.
L27
In order to reset the delay time, reach the maximum delay time and the next time
the sensor is pressed the delay time is cancelled and no LED is lit up, or if the
S6
delayed start has already been set, put the appliance on PAUSE and reset the time
as described earlier.
 Indicator LEDs
L28 L29L30
In addition to lighting up when their functions have been enabled, in combination with the red
LED of the START/PAUSE sensor, they notify the end user of any specific problems with the
appliance that may be solved without having to call for technical assistance (see page 26).
 Padlock:
When the related LED (L28) is lit, it indicates that all the sensors are disabled to prevent
children from altering, starting or pausing the cycle.
When enabled, touch any sensor and the LED flashes three times to remind the end user
that the appliance is locked.
Use the combination of two sensors (touch for approximately 5 seconds) illustrated in the figure below to
enable/disable this option.
P6 P3.0
15/104
Technical Support - MDM 599 77 39-16 Rev. 00