Tray Icons - Techsphere VP-II X User Manual

4. Tray Icons

VP-II X displays the current status of VP-II X with icons. The icons allow a Manager to quickly see the
current status of the VP-II X, see the icons and their descriptions in the table below:
Icon
Disconnected Network
Disconnected Server
Disconnected Master
Device
Tamper Switch Warning
Test mode
Disconnected VP-II XG
Attached USB
Status
1. Check Network cable connection.
2. Check Network settings on current system.
3. Check network status with Ping command.
4. Contact your network administrator.
1.
2.
3.
1. Check master device setting in Manager menu
2. Check the status of master device.
3. Contact your network administrator.
1. Check VP-II X status
2. Reset VP-II X on the wall or check the Tamper Switch
menu in a Manager menu.
3. Check that Tamper Switch is working
1. VP-II X is working in Test mode. If Test mode is
released, this icon will not be shown
1. Check cable between VP-II XG and VP-II X.
2. Check VP-II XG status.
3. Check Manager menu for VP-II XG setting.
1. USB key is attached.
Tips and Troubleshooting
IP address, Gateway, Subnet and etc.
Check server setting in the Manager menu.
Check your server status.
Contact network administrator
48