Operation Settings; Mode Settings (Network / Serial); Test Mode Release; Keypad Input Settings - Techsphere VP-II X User Manual

3. Operation Settings

3.1 Mode Settings (Network / Serial)

Manager Menu > 2. Operational Settings > 1. Mode Settings
Currently only the Network Mode is supported. Serial Mode is reserved for future use. Keep the default
setting.

3.2 Test Mode Release

Test Mode should be released after successful implementation once the system Managers are trained to
use the system and can verify themselves as Managers without any difficulties. Please refer to "Chapter
2 1.3 Test Mode" for details on what the Test Mode is and how it functions.
Test Mode can be released by the menu shown below:
Manager Menu > 2. Operational Settings > 2. Test Mode
If the Test Mode is released, the VP-II X does not show the Test Mode menu to enroll an Installer
anymore. There are two options in releasing the Test Mode.
If you select "Enable recovery function", before releasing the Test Mode, it can be recovered in this menu.
If you re-access this menu after releasing the Test Mode with "Enable recovery function" selected, it will
ask "Do you want to recover test mode?" to re-establish the Test Mode.
However, if you un-select "Enable recovery function" when releasing the Test Mode, the unit must be
sent back to the factory or to a Techsphere sales representative to recover the Test Mode. This function
is provided as a security feature, it must be sent back to manufacturer to recover the Test Mode.

3.3 Keypad Input Settings

If necessary, the keypad input can be disabled. If disabled, all keys will not respond. To re-enable, a
Manager must be verified with a card to access this menu or use the NetControl-X software to re-activate
the keypad. The beep sound of key input can also be disabled for silent operation.
32