Table of Contents
Advertisement
ENG
10. APPENDIX 1: VPM (VISUAL PARAMETER MANAGER)
10.1 Installation
Go to http://ksa.carel.com and select the following path:
Software & Support Confi guration & Updating Softwares Parametric
controller software
then select Visual Parametric Manager.
A dialogue box is opened, with the possibility to download 3 fi les:
1.
VPM_CD.zip: for burning a CD/DVD;
2.
Upgrade setup;
3.
Full setup: this is the complete program.
For fi rst installations, select Full setup, for upgrades select Upgrade setup.
The program is installed automatically by running setup.exe.
Important: if deciding to run the complete installation (Full setup),
uninstall any previous versions of VPM.
10.2 Opening the program
Programming can be performed using the key (IROPZKEYA0), connected
to the computer via the converter (IROPZPRG00).
When opening the VPM program, choose the device to be confi gured:
ir33. The Home page is displayed, with the options to create a new
project or open an existing project. Choose new project and enter the
password, which can be set as desired by the user the fi rst time. Select
the OEM profi le.
Then:
1.
upload the control parameters to the key, as described in chapter 2;
2.
read the parameters from the key.
10.3 Computer - key connection
To connect the computer to the key:
•
Select the list of parameters on the E2PROM key as the source;
ir33plus +0300028EN rel. 1.1 - 05.05.2017
Fig. 10.a
Fig. 10.b
•
Select the key connection port using the guided procedure (Wizard);
•
Connect the programming key to the converter..
10.4 Programming
Go to the "Confi gure device" page and select "Read"
A progress bar is displayed. When reading the data, the LEDs on the
converter fl ash, and at the bottom right the message "ONLINE" is
displayed.
50
Fig. 10.c
Fig. 10.d
Fig. 10.e
Fig. 10.f
Hide quick links:
Advertisement
Table of Contents
