X84; Problem - Cause - Solution - illy Y3.2 Instruction Manual

EN
PROBLEM - CAUSE - SOLUTION
PROBLEM
Power cord not connected to a power
The machine does not
socket.
switch on.
Power button in "0" position.
The water tank is empty.
The water tank is not correctly inserted. Insert the water tank correctly.
Incomplete closure of the moving part
of the machine head.
The machine does not
Capsule not inserted in the capsule
brew coffee.
compartment.
The capsule is not fully pierced.
Failure to start the pump.
The capsule is not ejected. The capsule is still in the compartment.
The water tank is empty.
The machine is too noisy. The water tank is not correctly inserted. Insert the tank correctly.
The capsule is not fully pierced.
Drops come out of
the dispensing spout, The machine is equipped with a valve
especially during the allowing to maintain constant pressure.
warm-up phase.
38
CAUSE
Connect the plug to a socket conforming to the technical data indicated in the data plate.
Switch the power button to the "I" position.
Fill the tank with water.
Lift the capsule compartment cover and make sure that a capsule has been inserted in the compartment. Lower the
lever up to the lock position. Try again and brew coffee.
Insert a capsule into the compartment.
Use a new capsule.
Make sure that there is no capsule inside the machine. Lower the opening lever up to the lock position.
Press any button to dispense water. Try again to brew coffee with a new capsule.
Close the opening lever completely, then slowly open it again, to ensure the ejection of the capsule into the removable
user capsule tray.
Fill the tank with water.
Use a new capsule.
THIS IS NOT A FAULT.
SOLUTION
Persistence of
the problem.
Contact
an authorised
service
centre.