X84; Descaling - illy Y3.2 Instruction Manual

EN
7 - DESCALING
If the and buttons flash alternately, the machine needs to be descaled. Read all instructions carefully before performing the descaling in order to familiarise yourself with the process.
The cycle lasts about 8 minutes.
NOTE: The descaling procedure can be started only when the machine is cold. If the operations are not carried out according to the indicated time, the machine will not start the descaling
process. In this case, turn off the machine and repeat the steps from the beginning.
Limescale normally builds up with the use of the machine. The machine is equipped with an automatic program allowing you to optimise cleaning and to remove limescale deposits
from the inside. The descaling procedure should be done at least every 2 months. Failure to descale the machine may cause malfunctions not covered by the warranty.
Only use descaling products for coffee machines. Do not use vinegar, lye, salt or formic acid as they may damage the machine. Follow the procedure described below and not the
instructions on the package of the descaling solution.
Turn off the machine.
Close the lever, do not enter any capsule.
28
1
Remove the tank and empty out the remaining
water.
5
Place a container of at least 0.75 litre capacity
under the dispensing spout.
2
Fill the tank with fresh water up to the maximum
level and let the descaling solution dissolve.
6
Turn on the machine.
3
Attach the tank containing the descaling solution.
7
3 sec.
Within 15 seconds from power on, press and hold
the button for 3 seconds.
4
8