AJA KONA LHe Plus Installation And Operation Manual page 49

Stereo 3D
A pulldown menu for 3D output allows you to select either Side-by-Side or Top-
Bottom (Stacked) output of left-eye and right-eye signals.
NOTE: This selection must agree with format selection in the third-party CineForm
Audio Ch
An Audio Channel pulldown allows you to select the number of embedded audio
channels for the HDMI output.
Protocol
The Protocol pulldown allows you to choose Auto Detect, HDMI or DVI protocol—
use DVI if you're outputting to a DVI monitor using an HDMI to DVI adapter.
Color Space
Selects the HDMI output color space and depth. These are the choices:
• Auto–UDC automatically selects the mode based on getting the attached
HDMI device's EDID information. This is the recommended setting. The
selected mode is shown to the right of the pull-down control.
• RGB 8Bit–UDC uses 8-bit RGB mode regardless of the attached device's EDID.
• RGB 10Bit–UDC uses 10-bit RGB mode regardless of the attached device's
EDID.
• YCbCr 10Bit–UDC uses 10-bit YCbCr mode regardless of the attached device's
EDID.
RGB Range
The RGB Range pulldown menu allows you to select the type of RGB color output.
• SMPTE– (typically 64-940)
• Full–(0-1023)
KONA LHi HDMI Input Settings
The detected HDMI input video format is displayed and you're given pull-
down menus to configure the RGB range (SMPTE or FULL) and select any two
embedded channel pairs from those supplied for stereo output (if applicable).
KONA Capture, Display, Convert v13.0
Codec (NOT included with AJA KONA 4/3G) pulldown menu.
49 www.aja.com