Configuration Parameters - Honeywell HMR3000 User Manual

4.0 CONFIGURATION PARAMETERS

This section describes the configuration parameters that can be set using HMR3000's configuration software.
4.1 O
PERATIONAL
Using the serial protocol described in the previous section, an external host can direct operation of the HMR3000 with
the following commands:
Command Description
Run 1 = Run
Stop 0 = Stop (Strobe mode)
Query query for Run/Stop status
Response Run
Stop
Force Reset Perform
sequence
Initialize Filters Reset
changing TC1)
power up reset
IIR filter (set after
Table 5.Basic operational parameters of the HMR3000
900240 Rev. B
Command Syntax
#FA0.3=1*26<CR><lf>
#FA0.3=0*27<CR><lf>
#FA0.3?*15<CR><lf>
#1*31<CR><lf>
#0*30<CR><lf>
#F33.6=1*52<CR><lf>
#F33.2=1*56
3/01
Action
Start Compass
measurements
Stop Compass
measurements
Respond with status
page 14