Environmental Protection - NOMA 052-6972-6 Instruction Manual

TROUBLESHOOTING
Problem
Possible reason
Light does · Wires are not properly connected.
not work
· Light bulbs are faulty.
· This fan is equipped with a 190 W
LIMITER that will automatically turn
the light o total wattage exceeds
the maximum wattage level.
Fan does
· Fan is in reverse (blades are moving in
not seem to
clockwise direction).
move much
air
· Fan is not properly located.
Fan wobbles
· Screws securing fan blade clips to motor
or shakes
are loose.
excessively
· Fan blade and its blade clip are not
fastened securely.
· Canopy and mounting bracket are not
tightened securely.
· Blades are unbalanced.
13

ENVIRONMENTAL PROTECTION

Discarded electrical appliances are recyclable and should not be discarded in your regular
domestic waste! Please actively support us in conserving resources and protecting the
environment by returning this appliance to a collection centre (if available).
Battery reclamation (please keep to comply with the local law).
Solution
· Ensure wire connector in switch
housing is connected.
· Unscrew light bulbs and discard
properly.
· Turn the power OFF and replace
the bulbs with lower wattage bulbs
so that the total wattage is below
190 W.
· Counter-clockwise (forward) is
recommended in warm weather.
rotation to stop. Use the eraser end
of a pencil to change the forward/
reverse slide switch.
· Place fan in the centre of the room
so there is at least 12" (30 cm)
between the end of the blades and
walls or other obstructions.
. Make sure that screws which attach
fan blade clips to motor are fastened
and tightened.
. Tighten screws of fan blade to blade
clip securely.
. Ensure that canopy and mounting
bracket are tightened securely to
ceiling joist.
. Check by selecting a point on the
ceiling above the tip of one of the
blades. Measure this distance and
ensure all blades are even (see Fig.
13). If all blade levels are not equal,
Touching
adjust accordingly (see Balancing Kit
ceiling
Manual).
9