Table of Contents
Advertisement
Reference
Serial Configuration
The Serial Set–up selection in the Configure menu, allows you to set
the communications parameters of the serial port on the rear-panel.
To modify the serial port setup, press the CONFIG button to access
the Configure menu. Use the up and down buttons ( and ) to select
SERIAL SET–UP. Press the enter button ( ) to enter the Config Serial
menu. Use the up and down buttons ( and ) to choose and change
any of the following selections:
1. Serial Mode.
Sets the mode of the serial port to either RS232 or RS485. Refer to
Serial Port Connection on page B–1 for connection information.
2. Unit Address.
Sets the RS485 serial mode address. A controlling terminal or PC
uses this address to identify and control a particular instrument.
3–8
DS1000 Series User Manual
Advertisement
Table of Contents
