Aruba AP-274 Installation Manual page 10

Figure 10 Mounting Bracket (AP-270-MNT-V1)
To install
AP
Figure 11 Mounting Bracket (AP-270-MNT-V2)
Mounting the AP to a Wall
1. Begin by marking the mounting points on the wall in the location you have selected.
a. Put the mounting bracket (included in the mount kit) on the installation position against the wall.
b. Using the mounting bracket as the template, mark four mounting points on the wall.
2. Use a drill to create four holes on the four markings you created in the previous step.
3. Insert a anchor bolt into each drilled hole. Anchor bolts are not included in the mount kit.
4. Place the mounting bracket over the anchor bolts and press the bracket against the wall.
5. Place the washers and nut onto the bolt's threaded end and tighten the nut till the mounting bracket is
firmly attached to the wall as shown in
Figure 12 Attaching the Mounting Bracket (AP-270-MNT-V1) to a Wall
10
To install
AP
Figure 12 or Figure 13.
AP-270 Series Outdoor Access Point | Installation Guide