Seat Ibiza Owner's Manual page 92

The time can also be set via the
function button in the Easy Connect
Setup
›››
system page 93.
Recommended gear
The recommended gear in order to save fuel
is displayed on the instrument panel while
›››

you are driving page
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
measurement (in miles or in km per hour).
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system via the
the function button
Setup
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››

page 30.
The speed warning settings can be adjusted
in the Easy Connect system via the
and the function button
Setup
90
Start-Stop operating display
key and

Updated information relating to the status is
displayed on the instrument panel
›››
page
Identifying letters on engine (MKB)
Hold the button
27.
than 15 seconds to display the identifying
letters of the vehicle engine (MKB). To do
this, the ignition must be switched on and
the engine switched off.
WARNING
Observe the safety warnings
symbols on page
WARNING
key and
Even though outside temperatures are above

›››
freezing, some roads and bridges may be icy.
page 93.
At outside temperatures above +4°C
●
(+39°F), even when the "ice crystal symbol"
is not visible, there may still be patches of ice
on the road.
● Do not rely on the outside temperature in-
dicator!
Note
Different versions of the instrument panel
●
are available and therefore the versions and
key

››› instructions on the display may vary. In the
page 93.
case of displays without warning or informa-
Operation
152.
›››
Fig. 105 down for more
4
›››
in Warning
92.
tion texts, faults are indicated exclusively by
the warning lamps.
● Depending on the equipment, some set-
tings and instructions can also be carried out
in the Easy Connect system.
● When several warnings are active at the
same time, the symbols are shown succes-
sively for a few seconds and will stay on until
the fault is rectified.
Odometer
Instrument panel: odometer and re-
Fig. 106
set button.
The distance covered is displayed in "kilome-
tres" or miles "m". It is possible to change
the measurement units (kilometres
"km"/miles "m") in the radio/Easy Connect*.
Please refer to the Easy Connect* Instructions
Manual for more details.