CAUTION
When the engine is cold, avoid high revs
●
and heavy acceleration and do not make the
engine work hard.
Rev counter
The rev counter indicates the number of en-
›››
gine revolutions per minute
Fig. 105
Together with the gear-change indicator, the
rev counter offers you the possibility of using
the engine of your vehicle at a suitable
speed.
The start of the red zone on the dial indicates
the maximum engine speed which may be
used briefly when the engine is warm and af-
ter it has been run in properly. Before reach-
ing this range, you should change to a higher
gear for vehicles with a manual gearbox or for
automatic gearboxes put the selector lever in
"D" or take your foot off the accelerator ped-
al.
We recommend that you avoid high revs and
that you follow the recommendations on the
gear-change indicator. Consult the additional
›››
information in
page 27, Gear-change
indicator.
Instruments and warning/control lamps
CAUTION
Never allow the rev counter needle
›››
Fig. 105
to go into the red zone on the
scale for more than a very brief period, other-
wise there is a risk of engine damage.
For the sake of the environment
Changing up a gear early will help you to save
fuel and minimise emissions and engine
.
1
noise.
Indications on the display
A variety of information can be viewed on the
instrument panel display
pending on the vehicle equipment:
Bonnet, rear lid and doors open
●
›››
page
27.
Information and warning texts.
●
●
Mileage.
Time.
●
●
Outside temperature.
Compass.
●
●
Recommended gear
Multifunction display (MFD) and menus
●
with different setting options
Service interval display
●
●
Second speed display
●
Speed warning function
Start-Stop system status display
●
1
›››
page
Identifying letters on engine (MKB).
●
Distance travelled
The odometer registers the total distance
travelled by the car.
The odometer ( trip ) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
Briefly press the button
●
set the trip recorder to 0.
›››
Fig. 105
de-
3
Keep the button
●
seconds and the previous value will be dis-
played.
Time
To set the time, keep the button
●
pressed for more than 3 seconds to select
4
the hour or minute display.
●
To continue setting the time, press the up-
per or lower part of the button
ton down to scroll through the numbers
›››
page
27.
quickly.
●
Press the button
›››
page
25.
setting the time.
›››
page
31.
›››
page
25.
›››
page
30.
152.
›››
Fig. 105
4
pressed for about 3
4
›››
Fig. 105
. Hold but-
4
again in order to finish
4
to re-
»
89