●
The temperature of the interior exceeds the
comfort limits (
button).
A/C
●
If the airflow is increased by more than 3
presses.
●
Temperature setting HI or LO is selected.
●
The engine coolant temperature is insuffi-
cient.
●
The alternator is faulty, for example the V-
belt has ruptured.
●
If any of the conditions described in the
previous section are not fulfilled.
When the engine is turned off by the Start-
Stop function, this is displayed on the instru-
ment panel.
If the Start-Stop system is not switched on,
the warning lamp will appear on the instru-
ment panel.
WARNING
Never allow the vehicle to move with the en-
gine off for any reason. You could lose control
of your vehicle. This could cause an accident
and serious injury.
●
The brake servo does not work with the en-
gine off. You need more force to stop the vehi-
cle.
●
Power steering does not work when the en-
gine is not running. That is why it is much
more difficult to turn the steering wheel.
●
Turn off the Start-Stop system when driving
through water (fording streams, etc.).
Driver assistance systems
Note
●
For vehicles with the Start-Stop function
and a manual gearbox, when the engine is
started, the clutch must be pressed.
●
When the conditions for the Start-Stop
function are not fulfilled, the instrument pan-
el displays the Start-Stop indicator dimmed.
●
If the steering wheel is turned more than
270°, it will not be possible to start the vehi-
cle again. To start the vehicle, straighten the
steering wheel so that it is turned less than
270°.
●
There are different versions of the dash
panel; the display of indications on the
screen may differ.
Activating and deactivating the Start-
Stop function
The Start-Stop function button.
Fig. 148
Every time the ignition is switched on, the
Start-Stop function is automatically activa-
ted.
Manually deactivating the Start-Stop func-
tion
›››
Press the
Fig. 148
button located on
–
the centre console. When the Start-Stop
function is switched off, the warning lamp
comes on.
If the Start-Stop function is operating then
–
the engine starts immediately.
Switching the Start-Stop function on manual-
ly
›››
Press the
Fig. 148
button located on
–
the centre console. The warning lamp will
switch off.
Fatigue detection (break rec-
ommendation)*
Introduction
›››
table on page 2
The Fatigue detection informs the driver
when their driving behaviour shows signs of
fatigue.
»
153