Adjusting height (front seats)
Press the button on the side and pull up-
–
wards to the desired position.
To lower the head restraint, press the but-
–
ton and push head restraint downwards.
Make sure that it engages securely into one
–
of its positions.
Adjusting height (rear seats)
Press the button on the side and pull up-
–
wards to the desired position.
To lower the head restraint, press the but-
–
ton and push head restraint downwards.
Make sure that the head restraint engages
–
securely in one of its positions
Removing the head restraint
Push the head restraint up as far as it will
–
go.
›››
Press the button
Fig. 124
(arrow).
–
Pull head restraint out of fitting without re-
–
leasing the button.
Fitting the head restraint
Insert the head restraint into the guides on
–
the corresponding backrest.
Push head restraint down.
–
Adjust the head restraint to suit body size
–
›››
page
55.
Seats and head restraints
WARNING
●
Never drive if the head restraints have been
removed. Risk of injury.
Never drive if the head restraints are in an
●
unsuitable position (the lowest position) as
there is a risk of serious injury.
After refitting the head restraint, you must
●
always adjust it properly for height to achieve
optimal protection.
Please observe the safety warnings in
●
in Correct adjustment of front head restraints
on page
55.
Note
●
To fit and remove the rear head restraints,
›››
gently tilt the seat backrest forwards.
page
55.
●
When fitting the head restraints again, in-
sert the tubes as far as possible into the
guides without pressing the button.
Seat functions
Heated seats*
›››
Front seat heating switch.
Fig. 125
The front seat cushions and backrests can be
heated electrically.
Press the corresponding switch
–
to switch on the seat heating.
Press once to connect the heating at maxi-
–
mum force. The two LEDs illuminate
›››
Fig.
125. After 15 minutes of high inten-
sity, the upper LED goes out, the system is
deactivated for 2 minutes and is then reac-
tivated at low intensity (the lower LED re-
mains on permanently).
Press the switch again to set the heating to
–
minimum force. (The lower LED lights up).
To disconnect the heating, press the switch
–
again.
›››
Fig. 125
»
119