● Initializing EX-2
When using the EX-2 for the first time, please carry
out the following settings.
※ EX-2 does will not work normally if the initial
confirguration is not set.
※ This is an operation method when the expansion
unit is not assembled.Initialization is necessary
using a different method when expansion unit is
put on, see p. 24 for more information.
1.
Power on while operating ET2 lever below.
Power ON
↓
ET2
↓
2.
Hold the ET2 lever until the LED of EX-2 turns
on (approximately two seconds).
3.
After the LED turns on, release ET2 lever.
Buzzer sounds, and reset is completed.
ET2
When changing each unit for a different unit, please
perform this initialization again.
● How to change the Modulation mode
EX-2 has two Modulation modes.
※ When attaching the Xpansion unit, this operation
is the same.
《Functions》
● General RC models FHSS mode : LEDSolid
Operating the general receivers such as
KR-211FH/KR-241FH
T h e r e c e i v e r i s a v a i l a b l e f o r o n l y F H S S
m e t h o d . T h e r e c e i v e r o f o t h e r m e t h o d s
(DSSS/27/40MHz) does not work.
● Mini-Z MHS mode : LED Flashing slowly
Oparating Kyosho Mini-Z MHS mode.
(MR-03 VE PRO)
Only MiniZ for MHS is available. Does not work with
the receiver for ASF, FHS, general RC cars.
① Turn off EX-2 switch.
② Push the ET1 lever to the left and power on.
③ Hold ET1 lever until the buzzer sounds and the
LED of EX-2 turns on (approximately two seconds).
PowerON
If the pilot LED is blinking fast, this is a warning
that the battery voltage is low. Please change to
new batteries or for a battery pack which has been
charged.
④ Set the Fail-Safe Function(p.15).
10
ET1
Approximately two seconds,
LED turns on.