Freewing F-14 TOMCAT User Manual page 5

Fuselage Installation
• Elevator
elevator servo installation
1. Use a servo tester or radio to center the
servo arm.
2. Use screw (A) to secure the servo (B) to the
elevator servo mount.
3. Insert the servo cable wire into the wire slot.
When wire installation is complete, use the
supplied tape to cover the slots.
4. Repeat these steps for the other side.
Elevator pushrod size
r.,____
66mm ( 2_ 31 5.>� Pushrod di a meter: 0 1.5 mm
Elevator pushrod mounting hole
Install Elevator
A- Screw (PA2.3x6mm 4pcs)
B - Metal elevator horn
C - Screw (Fm2x10mm 2pcs)
D - Nut (M2mm 2pcs)
E - Elevator rotational shaft
F - Screw (PM2x4mm 2pcs)
G - Elevator fixed ring
H - Elevator pushrod
I -Screw (PT3x8mm 4pcs)
F
Step
"'
,·
I
l
Note: Be aware of the screw depths when installing screws (I) to the elevator
rotational shaft. Ensure that the screws reach to the notched position on the
elevator rotational shaft to secure the elevators. Test it by trying to pull the
elevators back out, they should remain in place, if they slide out, reset the
screw's position until the elevators stay in place. Also, ensure that the elevators
are able to move freely afterwards.
•Main Wing
Main Wing Servo Installation
1. Use a servo tester or radio to center the
servo arm.
2. Use glue to secure the 17 g servo box (C)
and the control horn to the wing.
3. Insert the servo into the 17g servo box
(C) and feed the servo cable into the wire
slot (F). Secure the unit using the servo
box cover and 2 screws (A)
4. Use pushrod (E) to connect the servo
arm to the rudder control horn (D).
Aileron push rod size
Q
Pushrod di a meter : 0 1.5 mm
l -+-- 70mm ( 2-4/5")--+- �
Aileron pushrod mounting hole
1
.. ... •
�-- · · · · ·
F-14Tomcat
Item No., FJ308
Version No., FJ308-VO I
A- Screw (PWA2x8mm
B -17g servo
C - Elevator servo mount
Stepo
D
C
A-Screw (PWA1.7x5mm 2pcs)
B -Servo cover
C-Servo box
D- Horn
E - Pushrod
F -Servo cable Slot
Flap push rod size
········ ·· ··· ·· ·1
r.,____
�
2pcs)i:­
�
F
Flap pushrod mounting hole
L
1 .......
70mm ( 2-4/5")�
-4-
; - ; -
Servo cable slot
- ,a; � - - ;.1 · -�---,.: � ..,
c,; � )
·· ·· ·· ··· ·· ····1
�
N
..J