Dear Purchaser, Thank you for acquiring NEOLINE Wide S49 dashboard camera. Please carefully read this manual to the end in order to correctly use the device and extend its service life. Retain User Manual to consult it if necessary in future.
7. Disassembly or modification of the product is prohibited. 8. NEOLINE shall not be held responsible for loss of data and/or damage, whether direct or indirect, caused to the user or to a third party through improper use of the device or software, incorrect installation, use of accessories not included in the delivery set.
3. List of Equipment • Car dashboard camera NEOLINE Wide S49 • Rear view camera • Bracket with suction cup • Bracket with 3M scotch tape • Car charger • Operation manual • Warranty card...
4. Description of Device and Indicators 1) Button “Back” 10) Reset button 2) Button “Up” 11) Microphone 12) Power button 3) Button “Down” ( 4) Button “Enter” 13) mini-USB receptacle 5) Camera display 14) Memory card slot 15) HDMI output switchover button 6) Indicator 16) Rear view camera connector...
Page 8
Battery Condition Indicator Icon Description Battery fully charged. Battery 2/3 charged. Battery 1/3 charged. Battery discharged. Battery is charging. Connect car adapter to charge, battery is fully discharged. Note Please note that at temperatures below 0°С and above 45°C the power adapter will continue delivering power to the device but the lithium-ion battery will not be charged.
[ Installation of Dashboard Camera ] Windshield Mounting - Mount bracket on the device. Move it in the bracket holder till it goes click. - Remove protective film from adhesive bracket.
Page 10
- Firmly holding the bracket base on the windshield, check that the base is securely fixed. Adjustment of Device Position - Loosen knob to rotate the device vertically or horizontally. knob Then tighten the knob to securely fix the dashboard camera.
Page 11
Power Connection Only use power adapter included in the product delivery set to supply the device and charge the battery. - Connect one connector of power adapter to mini-USB receptacle on the device. - Connect other connector of power adapter to the car cigarette lighter socket. - After car engine is started, the device will automatically switch on.
[ Operation ] Preparation of the device . Insert icroSD card into the memory card slot. Switch off the device before memory card installation and insert memory card till it is fully fixed. Card installation: Position MicroSD card against the slot as shown on figure below and insert till it goes click.
Page 13
Switching ON/OFF Automatic ON/OFF After car engine is started, the device automatically switches on. Manual ON/OFF and Reset Manual ON/OFF To switch on the device manually, press power button. To switch off the device, press power button and hold it for at least 2 seconds. Reset Use a pin or paper clip to press reset button and hold it for 5 seconds (through the opening).
Page 14
Initial Adjustment Before using this device, it is necessary to set precise date and time as well as the network frequency Date / Time setting To correctly set date and time, carry out the following steps: to enter main menu. Press button to select Date / Time and press button Use buttons...
Page 15
Video recording Recording screen 9 10 11 12 1. Time of recording 2. Number plate stamp 3. Date/time stamp 4. Press to enter main menu 5. Press to enter Playback menu 6. Press to obtain photo 7. Press to block current recording 8.
Page 16
Emergency Recording To start emergency recording, carry out the following steps: - Press button OK during recording to block current video file against rerecording. “Emergency situation“ message will appear in left top corner of the screen. Note 1. If function Sensitivity G-sensor is activated and a collision happened, the device will automatically block current video file.
Page 17
Photographing You can take photos of current scene. to take a photo. During video recording, press Fatigue Warning If Fatigue Warning function is activated, one hour after the recording mode is started the device will generate an audio warning and then repeat it each half hour.
Page 18
Parking Mode Parking mode is intended to fix events at the parking place. -Press button to enter main menu. to select Parking mode and press button OK to -Use buttons - Use buttons select By G-sensor or By Motion Sensor and press button - Press button to exit menu.
Page 19
Note 1. If the battery is fully discharged, the dashboard camera can record information continuously for about 20 minutes. 2. In operation mode of the device, the battery capacity is gradually decreasing. This effect is normal for a battery. 3. Upon activation of By G-sensor, the file will be saved in folder Emergency Situation, upon activation of By Motion Sensor - in folder Video.
Page 20
Playback Screen Photo Viewing Screen Video Playback Screen Element Description File Type Current file type indication Filename Filename Elapsed time and recording time indication Current Playback Time Recording date and time Date/Time Press button Select File (back) to go back to Select File menu Press button to view the previous Previous File...
Page 21
button OK Deletion to select file to be deleted and press OK to enter - Use buttons File Deletion menu to select parameter - Use buttons Element Description Delete File Delete current file Delete All Delete all files - Press button to confirm deletion.
Page 22
File Deletion Delete File Delete All Note Deleted files cannot be restored. Create backup copies before deletion. Work with Menu General parameters can be set via main menu: - Press button to enter main menu. - Use buttons to select menu item and press button OK to enter the selected menu.
Page 23
Menu Elements MAIN MENU Resolution: 1080p 30fps / 720p 30fps Date/Time: use buttons to set current date and time Date/Time Stamp: ON/OFF Number Plate Stamp: use buttons to enter car number plate Audio Recording ON/OFF Button Click Sound: ON/OFF Volume: use buttons to set sound volume level Display Auto OFF: Off/7 seconds/1 minute/3 minutes Loop recording: 1 minute / 3 minutes / 5 minutes Exposure: -2..
[ Troubleshooting ] If problems have occurred while following the operational conditions, use this section to solve them. - Photographing and video recoding impossible Check whether there is enough free space on the MicroSD card as well as whether the card is not blocked. - Recording self-stoppage Too large size of video files, only use highspeed MicroSD cards, not lower than Class 10, of proven manufacturers.
Page 25
Manufacturer: DigiLife Technologies Co., Ltd 8F, No. 51, Ln. 258, Ruiguang Rd., Neihu District, Taipei City 114 Taiwan Made in China Official website: www.neoline.ru Technical support: support@neoline.ru In-warranty period: 12 months Service life: 36 months DC 5V, 1A Operating temperature -10...
Need help?
Do you have a question about the WIDE S49 and is the answer not in the manual?
Questions and answers