Set Up The Lacp System Priority For The Switch - NETGEAR GS750E User Manual

48-Port Gigabit Ethernet Smart Managed Plus Switch Model GS750E
5. Select System > LAG > LAG Membership.
6. In the LAG ID menu, select the LAG ID.
7. Enter a name in the LAG Name field.
You can enter a name of up to 15 alphanumeric characters.
8. Select the ports for the LAG by selecting the check boxes that are associated with the port numbers.
A LAG consists of at least two ports.
9. Click the Apply button.
Your settings are saved.
10. Select System > LAG > LAG Configuration.
11. Select the LAG ID of the LAG for which you just set up the port membership.
12. In the Admin Mode menu, select Enable.
13. In the LAG Type menu, select LACP.
The Port Member field for the selected LAG ID shows the ports that you selected in
The LAG Status field for the selected LAG ID shows whether the LAG is established (Up) or not
established (Down).
14. Click the Apply button.
Your settings are saved.

Set Up the LACP System Priority for the Switch

The LACP system priority specifies the link aggregation priority of the switch relative to the devices at the
other ends of the links on which link aggregation is enabled. The default is 32768. A higher value indicates
a lower priority. The value of the priority applies to all LACP LAGs that you set up on the switch.
Manage Network Settings
20
Step 8.