Sharp UX-B800A Service Manual page 20

UX-B800A
3. How to make soft switch setting
To enter the soft switch mode, press the following key entries in sequence.
Press FUNCTION 9
DATA No. 1 2 3 4 5 6 7 8
SW001 = 0 0 0 0 0 0 0 0
SW001 = 1 0 0 0 0 0 0 0
SW001 = 1 0 0 0 0 0 0 0
SW001 = 1 0 0 0 0 0 0 0
SW001 = 1 0 0 0 0 0 0 0
SW002 = 0 0 0 0 0 0 0 0
SW300 = 0 0 0 0 0 0 0 0
8 7
The soft switch mode is terminated.
START/MEMORY START/MEMORY
Press 1 or 0 key.
Press or < key.
Press or key.
>
Bit1 - 8 are set.
Press START/MEMORY
Soft SW002 - SW300 are set.
To finish the settings halfway between
SW001 and SW300, press the STOP
key. In this case, the setting being done
to the SW No. on display will be nullified
while settings done to the preceding
SW No. remain in effect.
When the COPY/HELP key is pressed, the
contents of soft switches are printed.
2 – 6
0 0 1
key during setting.