Display Panel - Philips VRZ360 Operator's Manual

VRZ360 4/7/99 9:53 PM

22 Display Panel

VCR Display Panel
Information about VCR operations appears
here. Different information appears at differ-
ent times. The display is brighter when the
VCR power is on. The display dims automati-
cally when you turn off the VCR power.
Cassette Compartment
Insert a tape here.
Operation indicators
These indicators tell you the
current operation of the VCR.
3 : Play, Forward and Reverse
Searching
\ : Record
\I : Record Pause
3I : Still Picture
Tape Speed Lights
This light indicates the current
tape speed. This VCR will play
tapes recorded in LP speed, but
LP will not appear on the display
panel. This VCR will not record in
LP speed. Details on tape speeds
are on pages 37 and 50.
VCR Light
This light appears when the VCR is
in VCR position.
Cassette-Inside Light
This light appears when a tape is in the VCR. It
blinks when a tape is being ejected. This light blinks
rapidly if the VCR is turned off to set a Timer
Recording but there is not a tape in the VCR.
Page 22
STILL/
POWER
PAUSE
VCR/TV
VIDEO L AUDIO R
ON SCREEN DISPLAY
lingual
HQ
SP SLP
VCR
Remote Sensor
Receives a signal from your remote
control so you can operate your VCR
from a distance. Press the VCR button
on the remote control before pressing
other VCR operation buttons.
PLAY
REW FF
STOP/EJECT
CHANNEL
REC/OTR
SP SLP
VCR
19 m Hi-Fi
Clock/Counter/Channel Display
Each time you press the EXIT/STATUS button,
information on the display panel will change.
When tape playback is stopped, press the
EXIT/STATUS button repeatedly to see: the cur-
rent time (when the clock is set); the real-time
counter; and the current channel number. During
tape playback, press the EXIT/STATUS button
repeatedly to see the real-time counter or the
current time.
Line Input Mode Light
When L appears here, the VCR is in Line Input
mode. When L-F appears, you have selected A/V
IN FRONT. Your audio and video cables should
be connected to the AUDIO/VIDEO jacks on the
front of the VCR if you are dubbing tapes. When
L-1 appears here, you have selected A/V IN REAR.
Your audio and video cables should be connected
to the AUDIO/VIDEO jacks on the back of the
VCR if you are dubbing tapes. To select A/V IN
FRONT or A/V IN REAR, press 0,0, then press
the CH(annel) 8/9 buttons so that A/V IN
FRONT or A/V IN REAR appears on-screen
briefly. To exit Line Input mode, press the
Number buttons or the CH(annel) 8/9 buttons
to select another channel.
TIMER Light
This light appears when a
timer recording is pro-
grammed or is in
progress. Details are on
pages 34 - 39. This light
blinks rapidly if the VCR
is turned off to set a
Timer Recording but a
tape is not in the VCR.