Index Search - Philips VRZ360 Operator's Manual

VRZ360 4/7/99 9:53 PM

42 Index Search

When you make a recording, the VCR automatically places an
index code at the beginning of the recording. Essentially, an index
code is a type of "bookmark" for your tape. This feature is useful
if you have several different programs recorded on a single tape.
Fast forward or rewind to the next or previous index code on the
tape by following the steps below.
1
Press the VCR button.
2
Make sure the VCR is in VCR position. (The VCR light will appear
on the display panel when the VCR is in VCR position.) If the
VCR light does not appear, press the VCR/TV button
once.
3
Insert a tape in the VCR.
4
Press the STOP 9 button to stop tape playback, if neces-
sary.
5
Press the INDEX --'
next index code on the tape. Or, press the INDEX ' ;;
button to rewind to the previous index code on the tape.
Wait for the VCR to fast forward or rewind the tape. When the
index code is reached, tape playback will begin automatically.
NOTE: You may press an INDEX button repeatedly to skip over
multiple recordings. For example, if you want to fast forward past
four recordings, press the INDEX --' button four times.
INDEX 4 will appear in the bottom right corner of the screen.
Page 42
button to fast forward to the
3 Insert a tape.
TV
VCR
– +
POWER
CBL/DBS
cEJECT
STILL/SLOW
MENU
PLAY
REW FF /OK
EXIT/STATUS
:
;; ::
L
STOP
TIMER [REC/OTR
S.SEARCH
1 2 3
+ +
CH
START STOP DATE
4 5 6
– –
DBS DAILY WEEKLY
7 8 9
VOL
0
SPEED CLEAR
QUICK PROGRAMMING
2
7;;INDEX ::7 AUDIO/MUTE
VCR/TV
Helpful Hints
• The VCR does not place an index
code at the point where a recording
is paused, then resumed.
• INDEX may flash on-screen briefly
when you begin a recording.
1
4
5