Advertisement
Gallagher T11 Reader
If you are not moun ng to a fl ush box, secure the base to the moun ng
surface using the four fi xing screws provided.
6-32 UNC screw
Building cable
6-32 UNC screw
4.
Connect the reader tail extending from the facia assembly to the building
cable. Connect the wires shown below.
Note: Do not cut the 'Reserved' wires, as these may be used for future
func ons.
5.
Fit the facia assembly into the base by clipping the small lip, into the top of the
base and holding the top, press the bo om of the facia assembly down into
the base.
6.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security
screwdriver) through the hole at the bo om of the base to secure the facia
assembly.
Note: The Torx security screw needs only to be lightly ghtened.
The recommended torque for the security screw is 0.7 Nm (0.5 lb/ ).
It is important not to exceed the maximum torque of 1.5 Nm (1.1 lb/ ).
Page 4
Posi ve
Red
Nega ve
Black
Reserved
Orange
Reserved
Green
Reserved
Brown
CDXIV TX
White
CDXIV RX
Blue
Installa on Note
Base
Edi on 10 | Part Number: 3E2513
November 2012
Advertisement
