Safety Precautions; Warning! Hazards That Could Result In Serious Injury Or Death; Caution! Hazards That Could Result In Moderate Injury - GLP JDC1 Instruction Manual

WWW.GLP.DE

1 Safety Precautions

The JDC1 and this instruction manual are intended for use by experienced
professionals with the knowledge and skills to set up, operate, and maintain
high-powered, remotely controlled lighting equipment safely and efficiently.
These operations require expertise that is not provided in this manual.
Read this manual and familiarize yourself with the safety precautions before
installing or using the product. The manufacturer will take no responsibility for
damages or harm caused by disregard for the information in this manual.
Should you have questions about the safe operation of the JDC1, please
contact an authorized GLP distributor, a list of which can be found at
www.glp.de.

1.1 WARNING! Hazards that Could Result in Serious Injury or Death

Do not look directly into the beam of light: brief exposure can cause eye injury.
Avoid exposing your eyes to direct radiation! Do not view the light output with
optical instruments or any device that may concentrate the beam.
Do not illuminate surfaces within 1 M (3.3 ft.) of the fixture. The light output is
powerful enough to cause burns or fire in illuminated objects at near range.
Hot surfaces! Surfaces on the head reach temperatures up to 160° C (320° F).
Avoid touching lights during the operation. This can cause injuries and/or
damage. Avoid placing lighting fixtures in locations where there is risk of
accidental contact by people or objects. Allow fixtures to cool before handling.
Do not place any filters or other objects on the glass plate. Do not block the light
output in any way. The glass becomes extremely hot during operation and can
melt or ignite objects in contact with the surface. The glass must remain clean
and unobstructed to prevent fire hazard and fixture damage.
Installation shall be performed by qualified personnel only in accordance with
local regulations. To prevent falls, suspend the JDC1 with hardware specifically
designed and rated for the purpose and a form of backup attachment such as
a safety cable.
Connect the fixture only to a grounded (earthed) power supply with overload
protection for protection against electric shock. Verify that power cables and
connectors are in good condition. Replace a blown fuse with one of the
specified rating only.

1.2 CAUTION! Hazards that Could Result in Moderate Injury

Avoid using strobe effects for extended periods. Flashing light, particularly
between 5 and 30 flashes per second, may cause seizures in persons with
photosensitive epilepsy. Check local regulations on use of strobe lighting and
notify the public in advance when strobe effects are used. If a seizure occurs,
4
JDC1
User Manual Rev. 1.0