Cisco ASR 9000 Series Configuration Manual page 37

Configuring Modular Quality of Service Packet Classification on Cisco ASR 9000 Series Routers
Command or Action
Step 5
police rate percent percentage
Example:
RP/0/RSP0/CPU0:router(config-pmap-c)# police
rate percent 50
Step 6
conform-action action
Example:
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
conform-action transmit
Step 7
exceed-action action
Example:
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
exceed-action drop
Step 8
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
end
or
RP/0/RSP0/CPU0:router(config-pmap-c-police)#
commit
OL-17239-01
How to Configure Modular QoS Packet Classification on Cisco ASR 9000 Series Routers
D r a f t — C i s c o C o n f i d e n t i a l
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
Purpose
Configures traffic policing and enters policy map police
configuration mode.
Configures the action to take on packets that conform to the
rate limit. The allowed action is:
transmit—Transmits the packets.
Configures the action to take on packets that exceed the rate
limit. The allowed action is:
drop—Drops the packet.
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
Entering no exits the configuration session and
–
returns the router to EXEC mode without
committing the configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or
committing the configuration changes.
Use the commit command to save the configuration
•
changes to the running configuration file and remain
within the configuration session.
QC-27