JVC MX-DVA5 Service Manual page 7

FL dispaly & system
control board
UCW3
Front panel
assembly
CD / DVD changer unit
Rear panel
Fig.6a
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and the CD / DVD changer unit.
1. Disconnect the card wire from connector FCW3 and
the harness from connector JCW1, JCW2 and
HCW3 on the inner side of the main board in the
body.
2. Remove the two screws E attaching the front panel
assembly on both sides of the body.
3. Remove the screw F attaching the earth terminal
extending from the cassette mechanism assembly.
4. Remove the screw G attaching the front panel
assembly and main board.
5. Remove the screw H attaching the front panel
assembly on the bottom of the body.
6. Release the two joints a on both sides and two joints
b on the bottom of the body using a screwdriver.
Fig.4
Adhesive card wire strap
D
Front panel assembly
(See Fig.7 to 9 )
Rear panel
Fig.5
CD / DVD changer unit
D
Fig.6b
Front panel assembly
FCW3
JCW2
Joint a
E
earth wire
MX-DVA5
C
Rear panel
Main board
JCW1
HCW3
F
Fig.7
1-7