JVC MX-DVA5 Service Manual page 16

MX-DVA5
Removing the motor.
1.
Remove the two screws C fixing the motor.
Be careful to grease's splash when the
drive belt comes off.(Fig.4, Fig.5)
2.
Unsolder the motor terminal.(Fig.4)
Removing the mechanism board.
1. Unsolder the four parts a on the solenoid
coil terminal.(Fig.4)
2. Remove the two screws D fixing the board.(Fig.4)
3. Unhook the three parts b from the board.(Fig.4)
4. Remove the mechanism board.(Fig.4)
Removing the flywheel.
Remove the cut-washers at c and d from the
capstan shaft, then remove the flywheel.
When reassembling the flywheel,
be sure to use new washers as they
cannot be reused. (Fig.7, Fig.8)
Flywheel
1-16
Flywheel
FR belt
Fig.7
Mecha.
terminal
board
b
a
D
Motor
Fig.4
Drive belt (Flat)
Capstan
washer
Fig.6
c
Sleeve
Washer
Flywheel
Fig.8
Motor
D b
C
a
C
Drive belt
Motor
Drive belt
Fig.5
Capstan
washer
d
Sleeve
FR belt