JVC MX-DVA5 Service Manual page 14

MX-DVA5
Removing the CD / DVD servo board
Prior to performing the following procedure, remove
the CD / DVD tray, the two screws attaching the
motor and detach the belt from the pulley.
1. Unsolder points the motor terminal.
2. Disconnect the card wire from the connector RCW1
on the CD / DVD servo board.
3. Disconnect the motor board wire from the motor
board connector on the motor board.
4. Remove the three screws D attaching the CD / DVD
servo board.
Removing the CD / DVD mechanism
holder assembly (mechanism included)
1. Disconnect the motor wire from connector on the
motor board in the CD / DVD mechanism holder
assembly on the under side of the CD / DVD
changer unit.
2. Disconnect the card wire from connector on the
pickup unit in the CD / DVD mechanism holder
assembly.
3. Remove the screw E attaching the shaft on the right
side of the CD / DVD mechanism holder assembly.
4. Pull outward the stopper fixing the shaft on the left
side and remove the CD / DVD mechanism holder
assembly from behind in the direction of the arrow
5. Pull out the CD / DVD mechanism holder assembly.
CD / DVD mechanism holder assembly
1-14
(See Fig. 12)
(See Fig.12 to 14)
CD/ DVD changer unit
Fig.13
D
RCW1
Motor board
CD / DVD mechanism
holder assembly
Connecter
Stopper
.
CD / DVD mechanism holder assembly
CD / DVD servo board
Solder
points
Motor board
connector
Fig.11
Motor board
E
Fig.12
Fig.14