JVC MX-DVA5 Service Manual page 13

Removing the sensor board, the LED
board and the turn table motor assembly
Prior to performing the following procedure, remove
the CD / DVD tray.
1. Remove the screw A attaching the LED board and
release the screws B attaching the bracket.
2. Remove the screw C attaching the sensor board and
release the two tabs b attaching the sensor board on
the under side of the CD / DVD tray.
3. Disconnect the harness from connector on the
sensor board and release the harness from the two
hooks c. Remove the sensor board.
4. Remove the screw D attaching the turn table. Detach
the turn table from the tray.
5. Pull outward the tab marked d attaching the turn
table motor assembly on the upper side of the tray
and detach the turn table motor assembly from the
tray.
Tray
Fig.8
Removing the belt, and the motor
Prior to performing the following procedure, remove
the CD / DVD tray.
1. Detach the belt from the pulley on the upper side of
the CD / DVD changer unit (Do not stain the belt with
grease).
2. Remove the two screws D attaching the motor.
LED board
(See Fig.6 to 9)
Turn table
D
(See Fig.10)
A
Fig.6
Tab c
Tab b
Fig.7
Turn table motor assembly
Fig.9
CD / DVD changer unit
Fig.10
MX-DVA5
B
C
Tab b
Connector
Sensor board
Tab d
D
Motor
Belt
1-13