Step 2 - Install The Modules - Extron electronics Cable Cubby 500 Installation Manual

Preparing the Cable Cubby
Step 1 — Assemble the connectivity modules of your choice.
Connectivity modules allow you to populate the Cable Cubby with a combination of AAPs, cable pass-through modules, or
Retractors.
AAP Module
NOTE:
After assembling the
module, proceed to "Step 2 —
Install the modules" below.
Cable Pass-Through Module
NOTE:
After assembling the module, proceed to "Step 2 — Install the modules" below.
3
Snap the included
hole plugs into
any unused holes.
2
Secure the
grommet plate
on the connectivity
bracket using two
of the provided
module screws.
Retractor Trim
Secure the Retractor trim
using the provided
mounting screws (2).
Step 2 — Install the modules.
Determine where the connectivity modules and power module will be installed
in the Cable Cubby. The modules may be installed at various heights.
NOTE:
Ensure that there is enough room above the
modules for the Cable Cubby lid to close completely.
For the power module:
WARNING: Risk of electric shock.
electrical grounding, use at least two of the provided
#6-32 mounting screws with the star washers.
AVERTISSEMENT : Risque de choc électrique.
Afin d'assurer une mise à la terre correcte, utilisez un
minimum de deux vis de mise à la terre #6-32 et les
rondelles en étoile fournies.
3
1
Secure up to two
single-space AAPs
in the AAP plate.
#4-40 Nut
w/ Captive Washer
For Show Me Cables:
1
Insert cables 1
through the
bottom of the
Flip grommet plate
connectivity
upside down and
bracket and into
insert Show Me
the holes of the
Cables into the
grommet plate.
grommet plate.
NOTE:
•
Use a screwdriver to secure the Retractor trim with the screws.
•
After installing the trim, proceed to "Step 2 — Install the
modules" below to install the power module.
•
Retractors are installed after the Cable Cubby is mounted on the
table (see
To ensure proper
For Show Me Cable
assemblies, only use the
top holes of the bracket.
2 2
Insert cables through the bottom I
of the connectivity bracket.
Connect cables to the AAPs.
2
Attach the Show Me
Cable Trim Plate to the
top of the module, using
the module screws.
3
Attach the grommet
plate to the bottom
of the module, using
the module screws.
Installing Retractors on page 5).
Use top
hole only.
3
Secure the AAP plate on the
connectivity brackets, using
two of the provided module
screws.
Connectivity bracket
2
Secure the modules
using the provided
mounting screws and
star washers on the
front and back of
the enclosure.
1
Insert the modules
into the Cable Cubby.