Table of Contents
Advertisement
Before first use
Packaging material
Remove all packaging material from
the inside of the appliance.
Protective film
The stainless steel trim on the interior
shelves and door shelves in the
appliance has a layer of protective film
to prevent scratching in transit.
Remove this protective film once the
appliance has been installed.
Cleaning and care
Please refer to the relevant
instructions in "Cleaning and care".
Important: Each time it is used, the
Miele Stainless Steel Cleaner forms a
water-repellant and dirt-repellant
protective coating.
Treat stainless steel surfaces with
Miele Stainless Steel Cleaner
immediately after removing the
protective film (see "Guide to the
appliance - Optional accessories").
Clean the inside of the appliance and
the accessories.
Clean the ice cube maker: Select the
"Rinse ice cube maker" setting and
the ice cube maker and the water
supply line will automatically be
rinsed out with water.
Switching on and off
Operating the appliance
A light touch on the sensors is all that is
required to operate this appliance.
A tone will sound each time a sensor is
touched. You can deactivate this if you
wish (see "Selecting additional settings
- Audible signals").
Switching on the appliance
Once the appliance is connected to the
electricity supply, the power supply
symbol will soon appear on the
display.
Touch the On/Off button.
The power supply symbol will go out
and the appliance will start to cool.
The sensors for the available sections
will appear on the control panel:
The section sensor is highlighted in
yellow and the current temperature in
this section appears on the display.
When the door is opened, the interior
lighting comes on and the LED lighting
on the shelves becomes brighter until it
reaches its maximum brightness.
When the appliance is switched on for
the first time, the sensor for the freezer
section and the alarm symbol will
flash until the set temperature is
reached.
21
Advertisement
Table of Contents
