Table of Contents
Advertisement
Frequently asked questions
Message
The ice cube maker
and alarm symbols
are flashing on the
display. The indicator
light on the ice cube
maker is also flashing.
The mains connection
symbol , appears on
the display and the
alarm sounds.
The temperature display
shows the warmest
temperature recorded in
the freezer section
during an interruption to
the power supply or a
power outage.
"F0 to F9" appears in
the display.
"FE*" appears on the
display.
The symbol has lit up
on the display and the
appliance is not cooling
although the controls
and the interior lighting
are working.
72
Possible cause and solution
There is a fault with the ice cube maker.
Contact Miele Service.
The temperature in the appliance over the past few
days or hours has risen too high because of a power
outage or an interruption to the power supply.
The appliance will go back to the last temperature
setting when the power comes back on.
Touch the alarm off button.
The warmest temperature display will go out. The
display will then revert to showing the current
temperature in the freezer section.
Depending on the temperature displayed, you
should check the condition of the food in the
freezer. If it has defrosted or started to defrost,
check that it is still safe to use and, if so, use it as
soon as possible. Defrosted food may only be re-
frozen after it has been cooked.
There is a fault.
Contact Miele Technical Service.
There is a fault.
Contact Miele Service.
Demo mode is on. This allows the appliance to be
presented in the showroom without the cooling
system being switched on. Do not activate this setting
for domestic use.
Turn off demo mode (see "Information for dealers -
Demo mode").
Advertisement
Table of Contents
