Rinsing - Whirlpool Vessi Use And Care Manual

CLEANING AND SANITIZING YOUR VESSI™
FERMENTOR & DISPENSER
Open the faucet for 2-3 seconds
until clear liquid is being dispensed�
Turn the faucet handle off and on
a few times while the liquid flows
5
through the lines� This ensures that
the faucet is cleaned�* Liquid can
be collected in the pitcher or any
other container�
*If using a faucet from another
manufacturer, check their cleaning
instructions�
Allow the faucet and draft line
6
to soak for 15 minutes�
Turn the 3-way valve knob to the
LIQUID INJECTION position� Flush
the LIS until you hear bubbling in
7
the vessel� This should take
2-3 seconds� Turn the 3-way valve
knob to OFF� This will empty the
LIS of the liquid�
CLEANING AND SANITIZING YOUR VESSI™ FERMENTOR & DISPENSER | 23
Reconnect the beverage port
cleaning line� Open the faucet
and let drain until all liquids are
removed� Make sure the pressure
in the vessel has reached 0 psi�
8
NOTE: All liquid is removed when
CO blows through the line� More
2
pressure may need to be added if
the pressure gauge reads 0 psi and
liquid is still present�

RINSING

Remove the 8" stainless steel cap,
1
gasket, and tri-clamp and place in
warm rinse water�
Repeat sections "Thorough
Cleaning of Vessel and Dispensing
Lines" and "Cleaning the Beverage
Lines" using warm rinse water
2
in place of brewers detergent
to thoroughly rinse the Vessi™
Fermentor & Dispenser�
NOTE: The 15 minute soak times are
not required for the rinsing process�