Thorough Cleaning Of Vessel And Dispensing Lines - Whirlpool Vessi Use And Care Manual

CLEANING AND SANITIZING YOUR VESSI™
FERMENTOR & DISPENSER
Clean the 2" cap, gasket, and tri-
clamp in brewers detergent� Rinse
8
and replace on the bottom of the
vessel� Hand-tighten only�
Remove the collection pan and
9
dispose of the contents� Replace
the collection pan�
THOROUGH CLEANING
OF VESSEL AND
DISPENSING LINES
LIS cap
Fill a 90° squeeze bottle (not
provided) with brewers detergent�
Remove the LIS cap and inject
prepared brewers detergent liquid
into the LIS reservoir until it slightly
overflows�
1
Place the LIS cap into brewers
detergent and let soak for 1 minute�
Replace cap�
Let the LIS soak for at least
15 minutes�
CLEANING AND SANITIZING YOUR VESSI™ FERMENTOR & DISPENSER | 21
CO port
2
Using the 90° squeeze bottle,
inject brewers detergent into
vessel CO port located on the
2
2
throat of the vessel� Use a dip
tube brush (not provided) to
clean inside the CO
Refill the 90° squeeze bottle and use
the entire contents to coat the inside
of the vessel� Scrub the inside of
3
the vessel as well as the groove and
neck at the top of the vessel using a
non-scratch scrub sponge�
Remove the 8" stainless steel
cap, gasket, and tri-clamp from
the brewers detergent� Scrub with
a non-scratch scrub sponge and
4
rinse� Replace the 8" stainless steel
cap onto the vessel� See "Sealing
the Vessel" in the "Preparing for
Fermentation" section�
port�
2