Cleaning The Beverage Lines - Whirlpool Vessi Use And Care Manual

CLEANING AND SANITIZING YOUR VESSI™
FERMENTOR & DISPENSER
CLEANING THE
BEVERAGE LINES
Verify that the faucet handle is in
1
the Off position (pushed all the
way back)�
Turn the 3-way valve knob to the
PRESSURIZE VESSEL position until
the console pressure gauge reads
2
10 psi� Turn the 3-way valve knob
to OFF� This pressurizes the vessel
to enable cleaning�
22 | CLEANING AND SANITIZING YOUR VESSI™ FERMENTOR & DISPENSER
IMPORTANT: Liquid will begin
flowing immediately when the
beverage line is inserted into the
beverage port� Be sure to have a
container ready to catch the liquid�
Also be prepared to disconnect the
3
beverage port after 2-3 seconds�
(See step 4�) Place the beverage
port cleaning line on the beverage
port to start the flow of liquid�
Allow to flow for 2-3 seconds until
clear liquid is being dispensed�
Disconnect the beverage port
cleaning line to stop the flow
of liquid�
To disconnect the beverage port
4
cleaning line, press on the gray tab
to release� Connect and disconnect
the beverage port cleaning line 2
times to help clean the fittings�