GE JTP16 Use And Care Manual page 15

How to Set Your Oven for Convection Roasting When Using the Temperature Probe
NOTE: For best results when roasting large turkeys
in the convection oven. For the correct placement of
the probe, see the description in the Regular Roastin&
section. -
The display will flash "PROBE" and the oven
control will signal if the probe is inserted into
the outlet, but the oven is not programmed for
the probe.
1. Place the shelf in the
lowest position (A).
Insert the probe
into the meat.
2. Plug the probe into
the outlet on the
oven wall. Make sure
it is pushed all the
oven door.
. .
I
pad until the desired internal probe
temperature is displayed.
5. Press the CONV. ROAST pad
CONV.
ROAST
J
6. Press the INCREASE or DECREASE pad.
The last oven set temperature appears in the
display. Continue pressing until the desired oven
temperature is displayed.
The oven will start automatically. The words
set will be in the display.
After a few seconds, the words "LO PROBE'. will
replace the roasting temperature in the display.
After the internal temperature of the meat reaches
7. When internal temperature of
meat reaches the number you
have set, the probe and the oven
turn off and the oven control
the CLEAWOFF pad. Use hot
pads to remove the probe from
the food. Do not use tongs to pull
on it—they might damage it.
CAUTION: To prevent possible burns, do not
unplug the probe from the oven outlet until the oven
has cooled. Do not store the probe in the oven.
NOTE:
If the probe is removed from the food before the
final temperature is reached, a tone will sound and
the display will flash until the probe is removed
from the oven.
The fan will stop when the door is opened but the
heat will not turn off.
A second fan may turn on and off to cool internal
parts. This is normal and the fan may continue to
run even after the oven is turned off.
You can use the timer even though you cannot use
timed oven operations.
To change oven temperature during Convection
Roast cycle, press the CONV. ROAST pad and
then press the INCREASE or DECREASE pad
to get the desired temperature.
new
15