Routing; Default Gateway; Static Route; R Outing 6.8.1 Default Gateway - VisionNet M505N User Manual

Assign Classification
Queue
Mark DSCP
Mark 802.1p Priority
Tag VLAN ID

6.8 Routing

6.8.1 Default Gateway

This page allows you to select a preferred WAN interface to be the system's default gateway.

6.8.2 Static Route

This page allows you to add the routing table. A maximum of 32 entries can be configured.
Click Add to configure the routing table. Enter the routing information and then click
Save/Apply.
Field
Destination Network
Address
Subnet Mask
Use Interface
Use Gateway IP Address
Select the classification queue for the traffic class.
Select the DSCP to mark. Different markers representing
different grades of service placed on various packet streams to
be recognized by the router for route purposes.
If 802.1q was enabled on WAN, then select a value between 0-7.
Enter a VLAN ID for the packet to tag.
Description
Enter the destination address of the LAN IP.
Enter the subnet mask of the LAN IP.
Check and select a WAN interface for static route.
Check and enter the gateway address of the remote router.
28
ADSL2/2+ 11N WiFi Router User's Manual