Troubleshooting - Subaru EyeSight Owner's Manual

Troubleshooting

Adaptive Cruise Control cannot be set.
Did you remember to press the
If you have not pressed the
Control) will not be shown.
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped,
meter display.
Set Adaptive Cruise Control again after the cause for the temporary stop has been
corrected.
Is displayed?
Adaptive Cruise Control cannot be set when
Cruise Control when
is not displayed.
Are the requirements for setting cruise control met?
In any of the following cases,
• The brake pedal is depressed.
• The vehicle speed is not between approximately 0 MPH (0 km/h) and 90
MPH (145 km/h) (when Adaptive Cruise Control is operating).
• The vehicle speed is not between approximately 20 MPH (30 km/h) and 90
MPH (145 km/h) (when Conventional Cruise Control is operating).
• The combination meter indicates a position other than
• The driver's seatbelt is unfastened.
• Any door is open (except the rear gate/trunk).
• The vehicle is on a steep grade.
• The steering wheel is turned significantly in either direction.
• Parking brake is applied.
• The X-mode is turned on (the X-mode indicator light
• The EyeSight system is stopped temporarily.
(CRUISE) switch?
(CRUISE) switch,
is displayed on the combination
is displayed.
will not be displayed.
Troubleshooting
(Adaptive Cruise
is not displayed. Set Adaptive
D M
or .
illuminates).
96