Advertisement
Quick Links
Genuine SUBARU part numbers: E5510SL000 (Turquoise blue)
Vehicle model:
To installation worker
This manual describes how to install and handle FRONT BUMPER
TRIM.
1. Before installation, be sure to read this manual for proper work.
2. The caution mark ⚠ in this manual indicates important instructions.
Strictly follow them.
3. SUBARU may not be held responsible for problems that occur due to
your failure to follow this installation manual.
⚠ Important instructions
1. Before starting installation work, move the vehicle to a safe location.
2. To work safely, make sure that the vehicle does not move.
（Make sure to apply parking brake.）
3. After turning the ignition off, disconnect the battery ground terminal.
4. Handle this product with care not to damage it or the vehicle.
Rev. No.
00
New establishment
FRONT BUMPER TRIM
E5510SL020 (Silver)
FORESTER 2025MY～
Revision content
Distributor: SUBARU Co., Ltd.
Δ00
Installation manual
Date
2023/8/9
1
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Subaru E5510SL000
Summary of Contents for Subaru E5510SL000
- Page 1 1. Before installation, be sure to read this manual for proper work. 2. The caution mark ⚠ in this manual indicates important instructions. Strictly follow them. 3. SUBARU may not be held responsible for problems that occur due to your failure to follow this installation manual. ⚠ Important instructions 1.
- Page 2 Completed installation sketch Front Bumper Trim Component parts ■E5510SL000 (turquoise blue) / E5510SL020 (silver） Item name Front Bumper Trim RH ① Front Bumper Trim LH ② ② ① Tools required for work Protective Plastic Cleaner Phillips head Gloves tape (Nonane is remover screwdriver recommended.)
- Page 3 Work procedures 1. Remove the front bumper. (1) To replace the molding with this product, remove the front bumper from the vehicle. ・Read the service manual to do this work. ・The removed parts are reused. Be careful not to lose or damage them during work. ・Be careful of harness connectors including sensors.
- Page 4 3. Replace the molding with this product. (1) Remove the screw (1 place) that fastens the molding to the bumper guard. (2) While widening the claw fitting portion (on bumper guard), remove the claws (8 places) on the molding from the vehicle inside. (A plastic remover helps remove claws easily.) (3) After removing all the claws, install this product to the bumper guard.
Need help?
Do you have a question about the E5510SL000 and is the answer not in the manual?
Questions and answers