Ricoh 5100WD General Settings Manual page 54

2. System Settings
The default setting is Vertical: 0.0% / Horizontal: 0.0%.
Specify the ratio between -1.0% and 1.0% (in 0.1% increments).
To set the Fine Ratio setting, measure the length of the original and the copy image to calculate the
ratio.
2
Fine Ratio Adjustment: Printer
Specify the fine ratio when the optional printer is installed. Depending on paper type, environment,
and humidity, copy paper can expand or shrink slightly. This means that the size of the copy and the
original do not match.
When the horizontal ratios are almost the same and there are differences between the vertical ratios,
you can specify the vertical correction ratio. You can make this setting for each paper type (plain,
translucent, film and recycled paper).
The default setting is 0.0%.
Specify the ratio between -1.0% and 1.0% (in 0.1% increments).
For details about how to set the fine ratio, see "Fine Ratio Adjustment: Copier".
Fold Width Fine Adjustment
Adjusts the fold width.
"Adjustment Value: Fan Folding Finisher" adjusts the Fan Fold width (shown as A, B, and C in the figure
below).
"Adjustment Value: Cross Folding Finisher" adjusts the Cross Fold width (shown as a, b, and c in the
figure below).
This menu appears only when the fan folding finisher or cross folding finisher is installed.
52
BLL006S