Cmos Clear; Watch Dog Enable/Disable - Supero X9DRL-EF User Manual

X9DRL-7F/X9DRL-EF Motherboard User's Manual

CMOS Clear

JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS.
Note 1. For an ATX power supply, you must completely shut down the sys-
tem, remove the AC power cord, and then short JBT1 to clear CMOS.
Note 2. Be sure to remove the onboard CMOS Battery before you short
JBT1 to clear CMOS.
Note 3. Clearing CMOS will also clear all passwords.

Watch Dog Enable/Disable

Watch Dog (JWD1) is a system monitor that
will reboot the system when a software ap-
plication hangs. Close Pins 1-2 to reset the
system if an application hangs. Close Pins
2-3 to generate a non-maskable interrupt
signal for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
JCOM2
BMC
JSTBY1
Battery
6-SGPIO2
X9DRL-7F/EF
Rev.1.01
6-SGPIO1
LSI 2208
CTRL
A
JMLED1
L-SAS4
SP1
L-SAS5
L-SAS6
L-SAS7
Intel PCH
I-SATA5
I-SATA4
I-SATA3
JBT1
I-SATA2
JSD1
T-SGPIO1
JL1
USB4
B
T-SGPIO2
I-SATA0
JBR1 FP CTRL
JWD1
JPME1
C
VGA
LAN
CTRL
LAN
CTRL
BIOS
CPU1
FANA FAN3
FAN4
Jumper Setting
Pins 1-2
Pins 2-3
Open
USB6/7
USB8/9
COM1
LAN2 LAN1
IPMI_LAN
CPU2
FAN1
FAN2
2-34
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
A. Clear CMOS
B. Watch Dog Enable