Switch-On Phase - Vega VEGAPULS WL 61 Operating Instructions Manual

Radar sensor for continuous level measurement of water and wastewater

Hide thumbs Also See for VEGAPULS WL 61:

Table of Contents

VEGAPULS WL 61 • Profibus PA

5.3

Switch-on phase

After connecting the instrument to power supply or after a voltage

recurrence, the instrument carries out a self-check for approx. 30 s:

•

Internal check of the electronics

•

Indication of the instrument type, hardware and software version,

measurement loop name on the display or PC

•

Indication of the status message "F 105 Determine measured

value" on the display or PC

•

The output signal jumps to the set fault current

As soon as a plausible measured value is found, the corresponding

current is outputted to the signal cable. The value corresponds to the

actual level as well as the settings already carried out, e.g. factory

setting.

5 Connecting to power supply

Table of Contents