HP FlexFabric 12500 Series Configuration Manual page 75

The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Set the CPU weight of MDCC to 5.
[Device-mdc-4-MDCC] limit-resource cpu weight 5
# Start MDCC.
[Device-mdc-4-MDCC] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-4-MDCC] quit
# Log in to MDCC from the default MDC.
[Device] switchto mdc MDCC
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCC for easy identification of the MDC.
[Device] sysname MDCC
# Assign an IP address to the virtual management Ethernet interface and enable the Telnet service
on the interface to allow remote management of MDC C.
[MDCC]interface M-Ethernet 0/0/0
[MDCC-M-Ethernet0/0/0]ip address 192.168.3.251 24
[MDCC-M-Ethernet0/0/0]quit
[MDCC]telnet server enable
[MDCC]user-interface vty 0 15
[MDCC-ui-vty0-15]authentication-mode none
[MDCC-ui-vty0-15]user-role mdc-admin
# Return to the default MDC.
[MDCC-ui-vty0-15] return
<MDCC> switchback
[Device]
Verifying the configuration
1. Check whether the MDCs exist and are operating correctly.
<Device> display mdc
ID
----------------------------------
1
2
3
4
2. Telnet to MDCA and view the running configuration of the MDC.
C:\> telnet 192.168.1.251
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
Name Status
Admin active
MDCA active
MDCB active
MDCC active
71
*
*
*
*
*