HP FlexFabric 12500 Series Configuration Manual page 74

This MDC was created successfully.
# Authorize MDCB to use the LPU in slot 3.
[Device-mdc-3-MDCB] location slot 3
# Assign interfaces GigabitEthernet 3/0/1 through GigabitEthernet 3/0/48 to MDCB.
[Device-mdc-3-MDCB] allocate interface GigabitEthernet 3/0/1 to GigabitEthernet
3/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Start MDCB.
[Device-mdc-3-MDCB] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-3-MDCB] quit
# Log in to MDCB from the default MDC.
[Device] switchto mdc MDCB
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCB for easy identification of the MDC.
[Device] sysname MDCB
# Assign an IP address to the virtual management Ethernet interface and enable the Telnet service
on the interface to allow remote management of MDC B.
[MDCB]interface M-Ethernet 0/0/0
[MDCB-M-Ethernet0/0/0]ip address 192.168.2.251 24
[MDCB-M-Ethernet0/0/0]quit
[MDCB]telnet server enable
[MDCB]user-interface vty 0 15
[MDCB-ui-vty0-15]authentication-mode none
[MDCB-ui-vty0-15]user-role mdc-admin
# Return to the default MDC.
[MDCB-ui-vty0-15] return
<MDCB> switchback
[Device]
4. Create and configure MDCC for Company C:
# Create MDCC.
[Device] mdc MDCC
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCC to use the LPU in slot 4.
[Device-mdc-4-MDCC] location slot 4
# Assign interfaces GigabitEthernet 4/0/1 through GigabitEthernet 4/0/48 to MDCC.
[Device-mdc-4-MDCC] allocate interface GigabitEthernet 4/0/1 to GigabitEthernet
4/0/48
70
*
*
*