HP FlexFabric 12500 Series Configuration Manual page 73

# Create MDCA.
<Device> system-view
[Device] mdc MDCA
It will take some time to create MDC...
This MDC was created successfully.
# Authorize MDCA to use the LPU in slot 2.
[Device-mdc-2-MDCA] location slot 2
# Assign interfaces GigabitEthernet 2/0/1 through GigabitEthernet 2/0/48 to MDCA.
[Device-mdc-2-MDCA] allocate interface GigabitEthernet 2/0/1 to GigabitEthernet
2/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Configure MDCA to use up to 40 percent of the total disk space.
[Device-mdc-2-MDCA] limit-resource disk slot 1 ratio 40
# Start MDCA.
[Device-mdc-2-MDCA] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-2-MDCA] quit
# Log in to MDCA from the default MDC.
[Device] switchto mdc MDCA
******************************************************************************
* Copyright (c) 2010-2014 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
<Device> system-view
# Change the device name to MDCA for easy identification of the MDC.
[Device] sysname MDCA
# Assign an IP address to the virtual management Ethernet interface and enable the Telnet service
on the interface to allow remote management of MDC A.
[MDCA]interface M-Ethernet 0/0/0
[MDCA-M-Ethernet0/0/0]ip address 192.168.1.251 24
[MDCA-M-Ethernet0/0/0]quit
[MDCA]telnet server enable
[MDCA]user-interface vty 0 15
[MDCA-ui-vty0-15]authentication-mode none
[MDCA-ui-vty0-15]user-role mdc-admin
# Return to the default MDC.
[MDCA-ui-vty0-15] return
<MDCA> switchback
[Device]
3. Create and configure MDCB for Company B:
# Create MDCB.
[Device] mdc MDCB
It will take some time to create MDC...
69
*
*
*