Elcometer 510 User Manual page 7

4 GETTING STARTED (continued)
4.3 SCREEN SETTINGS
A number of screen settings can be defined by the user via
Menu/Setup/Screen Settings including:
Screen Brightness; This can be set to 'Manual' or 'Auto' - the

brightness is adjusted automatically using the gauge's ambient
light sensor.
Screen Timeout; The display will dim if inactive for more than

15 seconds and will go 'black' if inactive for the period defined.
The gauge can also be set to switch off automatically after a user
defined period of inactivity via Menu/Setup/Gauge Auto Off. The
default setting is 5 minutes.
Screen Rotation; Using the internal accelerometer, the gauge

rotates the display to allow the user to easily read the pressure
value at 0° or 180° orientation ('Auto Display Rotation').
4.4 SETTING UP THE READING DISPLAY
The colour display is split into two halves; Top Display and Bottom
Display. The user can define what information is displayed in each
half including: Readings, Selected Statistics and Run Chart.
To setup the display:
1 Press Display/Setup Display/Top Display (or Bottom Display as
required).

2 Use the
'Select'.
If 'None' is selected for one half and 'Readings' or 'Run Chart' for the
other half, the readings or run chart will fill the whole screen. If any
other combination of options is selected; the data will be shown in the
top or bottom display as specified.
Readings (Fig. 1); The last reading is

displayed under the current pressure
reading and is only updated when the
current reading is saved.
www.elcometer.com
softkeys to highlight the required option and press

Fig. 1: Readings
en-6
R