D-Link DPH-150S Quick Installation Manual page 56

 Blue part (name)
"Group 1","Group 2" and "Group 3" are your setting monitoring multicast name.The
group name will be displayed on the screen when you answer the multicast. If you have not
set, the screen will display the IP: port directly.
 Purple part (host: port)
It is a set of addresses and ports to listen, separated by a colon.
 Pink part (index / priority)
Multicast is a sign of listening, but also the monitoring multicast priority. The smaller
number refers to higher priority.
 Red part (priority)
It is the general call, non multicast call priority. The smaller number refers to high
priority. The followings will explain how to use this option:
 The purpose of setting monitoring multicast "Group 1" or "Group 2" or "Group 3"
launched a multicast call.
 All equipment has one or more common non multicast communication.
 When you set the Priority for the disable, multicast any level will not answer, multicast
call is rejected.
 when you set the Priority to a value, only higher than the priority of multicast can come
in, if you set the Priority is 3, group 2 and group 3 for priority level equal to 3 and less
than 3 were rejected, 1 priority is 2 higher than ordinary call priority device can answer
the multicast message at the same time, keep the hold the other call.
 Green part (Enable Page priority)
Set whether to open more priority is the priority of multicast, multicast is pink part
number. Explain how to use:
 The purpose of setting monitoring multicast "group 1" or "3" set up listening "group of
1" or "3" multicast address multicast call.
 All equipment has been a path or multi-path multicast phone, such as listening to
"multicast information group 2".
 If multicast is a new "group of 1", because "the priority group 1" is 2, higher than the
56
/ 68