D-Link DPH-150S Quick Installation Manual page 55

device, monitor and play the RTP stream which sent by the multicast address.
MCAST Settings
Equipment can be set up to monitor up to 10 different multicast addresses, used to
receive the multicast RTP stream sent by the multicast address.
Here are the ways to change equipment receiving multicast RTP stream processing
mode in the Web interface: set the ordinary priority and enable page priority.
 Priority:
In the drop-down box to choose priority of ordinary calls the priority, if the priority
of the incoming flows of multicast RTP, lower precedence than the current common calls,
device will automatically ignore the group RTP stream. If the priority of the incoming
flow of multicast RTP is higher than the current common calls priority, device will
automatically receive the group RTP stream, and keep the current common calls in state.
You can also choose to disable in the receiving threshold drop-down box, the device will
automatically ignore all local network multicast RTP stream.
 The options are as follows:
 1-10: To definite the priority of the common calls, 1 is the top level while 10 is the
lowest
 Disable: ignore all incoming multicast RTP stream
 Enable the page priority:
Page priority determines the device how to deal with the new receiving multicast
RTP stream when it is in multicast session currently. When Page priority switch is
enabled, the device will automatically ignore the low priority multicast RTP stream
but receive top-level priority multicast RTP stream, and keep the current multicast
session in state; If it is not enabled, the device will automatically ignore all receiving
multicast RTP stream.
 Web Settings:
The multicast SS priority is higher than that of EE, which is the highest priority.
Note: when pressing the multicast key for multicast session, both multicast sender and
receiver will beep.
55
/ 68