Leds; Usb Console Led - Cisco Catalyst 9300 Series Hardware Installation Manual

LEDs

Table 2: Network Modules
Network Module
C9300-NM-4G
C9300-NM-8X
C9300-NM-2Q
C9300-NM-BLANK
1 All network modules are hot-swappable.
For information about the network modules, see the
For cable specifications, see
LEDs
You can use the switch LEDs to monitor switch activity and its performance.
Figure 4: Switch Front Panel LEDs

USB Console LED

The USB console LED shows whether there is an active USB connection to the port.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
6
1
Description
This module has four 1G SFP module slots. Any combination of standard SFP
modules are supported. SFP+ modules are not supported.
If you insert an SFP+ module in the 1G network module, the SFP+ module does
not operate, and the switch logs an error message.
This module has eight 10G slots with an SFP+ port in each slot. Each port
supports a 1G or 10G connection.
This module has two 40G slots with a QSFP+ connector in each slot.
Insert this blank module when the switch has no uplink ports (this is required
for sufficient air flow).
Cables and Adapters, on page
Installing a Network Module in the Switch, on page
81.
Product Overview
40.